Floriani
Medium Cutaway
Floriani
Medium Cutaway/Medium Cutaway Fusible is a very soft yet solid
2.0 oz stabilizer that will support medium to heavy stitch count
designs. It is ideal for fabrics that are considered un-stable;
fabrics such as fleece, t-shirts, sweatshirts, polo knit, etc.
Floriani Medium Cutaway Fusible stabilizer has a light fusible
coating and is ideal for knits that tend to distort or stretch
when they are hooped and/or when the embroidery is forming. The
uniqueness of this product is the fact that it is fusible. This
eliminates the need for messy spray adhesives which leave a residue
on the needle, machine and fabric. By fusing the stabilizer to
the back of the garment, embroiderer's are more successful in
hooping and do not stretch the garment out of shape. Most importantly,
the stabilizer is attached to the entire area where the embroidery
will be stitched unlike spray adhesives which only "spot"
tack and allow shifting of the fabric.
-
Use
on non-stable stretch fabrics
-
Will support a design density of about 14,000 stitches and
well digitized.
-
Super
soft feel makes it ideal for sweatshirts, fleece and sweater
knits.
-
Available
in a fusible version which eliminates the need for spray adhesives
or basting.
To
use Floriani Medium Cutaway:
-
Cut
a piece of the stabilizer at least one inch larger than the
hoop size you are planning to use.
-
Place the stabilizer to the wrong side of the fabric and hoop.
Note! If using the fusible version, use a low to medium temp,
dry iron (260°F, silk setting) to adhere to stabilizer
to the back side of the fabric. The surface of the iron should
touch the fabric not the stabilizer. Use a pressing cloth
if necessary.
-
Place the embroidery frame on the machine and complete the
design. Note! If the design is denser than 14,000 stitches
or if it is a poorly digitized design (too many stitches for
the designs size), float an additional layer of Floriani Medium
Tearaway between the hoop and the bed of the machine for each
additional 10,000 stitches for added support.
-
Once the design is complete, remove the hoop and garment from
the machine and trim the stabilizer close to the design. If
you have fused the stabilizer to the garment, apply heat and
then pull it to the designs edge before trimming.
Floriani's
Cutaway Medium Product Identity
FCM1210 12" x 10 yds 2
oz
FCM1225 12" x 25 yds 2
oz
|
