|
Sheer
Magic Plus
Fusible Woven Support for Dense Embroidery on Light Fabrics
Adding
embroidery to some fabrics can cause distortion. This can
be due to the density of the embroidery or the lack of thread
count in the fabric. Adding a high stitch count embroidery
design to fabrics like quilt cotton, batiste or silk can
cause puckering and/or uneven outlines. Fusing Sheer Magic
Plus to the fabric before stabilizing will give the needed
support for the embroidery to relax and lay properly. Sheer
Magic Plus will not change the drape of the material but
removes the need for "over stabilizing" which
can cause the design to become hard or stiff.
- Creates a
bond with delicate fabrics without changing the face or
drape of the fabric
- Fuse over
the back of an embroidery design to cover scratchy stitches.
- Keeps fabric
from raveling or shredding during the embroidery or stitching
process.
- Available
in Natural and Black
To use Sheer
Magic Plus:
- Cut a piece
of Sheer Magic at least one inch larger than the embroidery
design area.
- Place the
fusible side (textured side) of Sheer Magic Plus to the
wrong side of the fabric and press using a low temp, dry
iron (silk setting) **It is necessary to use a pressing
cloth or sheet between the iron and Sheer Magic Plus.
- Using the
appropriate stabilizer in addition to Sheer Magic Plus,
embroider or embellish the garment.
If desired, after
the embroidery is complete, fuse one layer of Sheer Magic
Plus over the back of the design to keep it from scratching
the wearer's skin. Use a burst of steam to create a permanent
bond between Sheer Magic and the base fabric. **Refer
to step two when fusing.
Sizes
available: 30" x 3 yds, 30" x 25 yds
|
