NOW AVAILABLE IN NEW TAPE SIZE & 8.5" x 11" Printable Sheets! This fibrous water-soluble stabilizer features a pressure sensitive coating for holding hard to hoop items in place while you stitch or embroider.  The water soluble base does a beautiful job of supporting dense embroidery designs on most fabric styles where complete stabilizer removal is desired.  Use for holding down corners of napkins and handkerchiefs, collars and cuffs as well as the edges of hand towels, ribbons and more!  Use the new tape size rolls for turning up hems for flawless stitching, securing decorative trims and edging or use as an ideal foundation for built in decorative stitches.  The new printable sheets provide a perfect template for thread painting, red-work, cross-stitch, bead work and more!   To use regular Wet N Gone® for free standing lace and/or embroideries: Hoop one layer of the stabilizer within the embroider frame. Try to achieve "tight as a drum" tension without stretching or distorting the stabilizer. Embroider the design. Remove the product from the hoop and trim away as much of the stabilizer as possible. Rinse away the Wet N Gone® using luke warm water. *Tip - If your desire is to have the lace stiff, simply get the embroidery wet. Don't rinse! Once it is wet, the stabilizer will be absorbed into the stitching and will dry stiff. Now, Floriani has created printable, pre-cut sheets of this extraordinary product to expand your creative possibilities!  Create templates that will adhere and then wash out.  Use for a variety of surface embellishment projects such as bead-work, thread painting, red-work, cross-stitch, needlepoint, crewel embroidery and more!  To use – print the image directly onto the Wet N Gone Tacky sheet using a light color of ink, remove the release paper, stick down the template and stitch!

1. Fuse one layer of the stabilizer on to the back of the fabric. Be sure to use a piece at least one inch larger than the outer parameter of the hoop to insure proper stabilization. *Important - Use a low temp (260°, silk) setting on your iron. Do not touch the surface of your iron to the Wet N Gone Fusible®, use a press cloth (muslin or cotton). Press quickly! It is not necessary to hold the iron to the fabric for more than three seconds.
   
2. Repeat steps 2-4 from above.

To use Wet N Gone Tacky®:

1. Place one layer of the product in your embroidery hoop, paper side up.
   
2. Score the release paper with a pin or needle and peel back.
   
3. Stick the garment or item to be embroidered in place and smooth out any wrinkles.
   *Tip - It is necessary to use "soft" water to get optimal rinse results with this product.
   
4. Repeat steps 2 - 4 from above

Floriani's Wet N Gone Tacky Product Identity

FWGT910          9" x 10 yds  
FWGT1210        12" x 10 yds  
FWGT2010        20" x 10 yds  
FWGTS             20 Sheets 8.5" x 11"
FWGT-1X10       1" x 10 yds
FWGT-1/2X10    1/2" x 10 yds